SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA201886 GT, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTEXTERIOR LIGHTSLIGHTING SYSTEM (EXT) (SERVICE INFORMATION)FOG LIGHT ASSEMBLYREMOVAL [03/2017 - ]PROCEDURE
2018 Toyota 86 GT, Standard Trans

Removal [03/2017 - ]: Procedure

2018 Toyota 86 GT, Standard TransSECTION Procedure
  1. SEPARATE FRONT FENDER LINER 
    1. Remove the bolt.
      GTY706864Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 3 clips and partially remove the front fender liner.
  2. REMOVE FOG LIGHT ASSEMBLY 
    1. Disconnect the connector.
      GTY693578Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 screws A.
    3. Disengage the clip B and remove the fog light assembly.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.