Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSTOYOTA20184RUNNER SR5, 4WDREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEMSENGINE CONTROL SYSTEM - SERVICE INFORMATIONACCELERATOR PEDALREMOVAL [08/2015 - ]PROCEDURE

2018 Toyota 4Runner SR5, 4WD

Removal [08/2015 - ]: Procedure

2018 Toyota 4Runner SR5, 4WDSECTION Procedure

REMOVE ACCELERATOR PEDAL SENSOR ASSEMBLY

NOTE:

Avoid physical shocks to the accelerator pedal sensor assembly.
Do not disassemble the accelerator pedal sensor assembly.
This accelerator pedal does not require lubrication. Do not apply oil or other lubrication to the accelerator pedal sensor assembly. If applied, the accelerator pedal sensor assembly must be replaced.

Disconnect the accelerator pedal position sensor connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the 2 nuts and accelerator pedal sensor.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.