Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA20184RUNNER SR5, 4WDREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSWINDOWS / GLASS - SERVICE INFORMATIONREAR POWER WINDOW SWITCHINSTALLATION [08/2015 - ]PROCEDURE
2018 Toyota 4Runner SR5, 4WD
Installation [08/2015 - ]: Procedure
2018 Toyota 4Runner SR5, 4WDSECTION Procedure
- INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY
- Attach the 2 claws to install the power window regulator switch assembly to the base panel.
- Connect the connector.
- Attach the 10 claws to the install the power window regulator switch with base panel.
- INSTALL REAR DOOR INNER GLASS WEATHERSTRIP LH
Refer to PROCEDURE - Step 35
- INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
Refer to PROCEDURE - Step 36
- INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH
Refer to PROCEDURE - Step 37
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.