Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA20184RUNNER SR5, 4WDREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSWINDOWS / GLASS - SERVICE INFORMATIONPOWER WINDOW MASTER SWITCHINSTALLATION [08/2015 - ]PROCEDURE
2018 Toyota 4Runner SR5, 4WD
Installation [08/2015 - ]: Procedure
2018 Toyota 4Runner SR5, 4WDSECTION Procedure
- INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY
- Install the multiplex network master switch assembly with the 3 screws.
- Attach the 10 claws to install the multiplex network master switch with base panel.
- Connect the connector.
- INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP LH
Refer to PROCEDURE - Step 38
- INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
Refer to PROCEDURE - Step 39
- INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH
Refer to PROCEDURE - Step 40
- INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH
Refer to PROCEDURE - Step 41
- INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH
Refer to PROCEDURE - Step 40
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.