Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2013SEQUOIA LIMITED, 5.7L ENG VIN WREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 16 (ENGINE CONTROL SYSTEM (3UR-FE) (SERVICE INFORMATION))CAMSHAFT POSITION SENSORREMOVALREMOVAL
2013 Toyota Sequoia Limited, 5.7L Eng VIN W
Camshaft Position Sensor: Removal: Removal
2013 Toyota Sequoia Limited, 5.7L Eng VIN WSECTION Removal
WARNING: This page is about a different variant/trim than selected.
- REMOVE V-BANK COVER SUB-ASSEMBLY . Refer to REMOVAL - Step 2
- REMOVE AIR CLEANER HOSE ASSEMBLY . Refer to REMOVAL - Step 3
- REMOVE CAMSHAFT POSITION SENSOR
- Disconnect the sensor connector.
- Remove the bolt and sensor.
- REMOVE VVT SENSOR
- Disconnect the 4 sensor connectors.
- Remove the 4 bolts and 4 sensors.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.