SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2012PRIUS THREEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 41 (ENGINE CONTROL SYSTEM (PLUG-IN) (DIAGNOSTIC CODES (P0505-U0293) & CIRCUIT TESTS))SFI SYSTEMDTC P060A: INTERNAL CONTROL MODULE MONITORING PROCESSOR PERFORMANCEPROCEDURE
2012 Toyota Prius Three

DTC P060A: Internal Control Module Monitoring Processor Performance: Procedure

2012 Toyota Prius ThreeSECTION Procedure
WARNING: This page is about a different variant/trim than selected.
  1. READ OUTPUT DTC (DTC P060A) 
    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Turn the Techstream on.
    4. Clear the DTCs. Refer to DTC CHECK / CLEAR .
    5. Turn the power switch off and turn the Techstream off.
    6. Disconnect the Techstream.
    7. Disconnect the cable from the negative (-) auxiliary battery terminal and wait for 1 minute.
    8. Connect the cable to the negative (-) auxiliary battery terminal.
    9. Connect the Techstream to the DLC3.
    10. Turn the power switch on (IG).
    11. Turn the Techstream on.
    12. Wait 16 seconds or more.
    13. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
    14. Read the DTCs.
      RESULT

      Result Proceed to
      DTC is not output A
      DTC P060A is output B

    B → See step   3 

    A → See step   2 

  2. CHECK FOR INTERMITTENT PROBLEMS. Refer to  CHECK FOR INTERMITTENT PROBLEMS 
  3. REPLACE ECM. Refer to  REMOVAL 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.