Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2012PRIUS THREEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 115 (SMART KEY SYSTEM (KEYLESS START) (PLUG-IN) (DIAGNOSTIC CODES & SYMPTOM TESTS))SMART KEY SYSTEM (FOR START FUNCTION)DTC B2277: DETECTING VEHICLE SUBMERSIONDESCRIPTION
2012 Toyota Prius Three
DTC B2277: Detecting Vehicle Submersion: Description
2012 Toyota Prius ThreeSECTION Description
WARNING: This page is about a different variant/trim than selected.
This DTC is stored when the submersion circuit monitor inside the power management control ECU detects a large amount of water.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2277 | The submersion circuit monitor inside the power management control ECU detects a large amount of water. | Power management control ECU |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.