DTC C1380/64: Stop Light Control Relay Malfunction: Description

2012 Toyota Prius ThreeSECTION Description

Upon receiving the dynamic radar cruise control system operating signal from the skid control ECU, the relay contact turns on and the stop light comes on.

DTC Code INF Code DTC Detection Condition Trouble Area
C1380/64 761 When the voltage at the IG1 terminal is 9.5 V or more and the stop light control relay drive output (STP0) is ON, a signal is not input to the STP2 terminal for 2 seconds or more.
  • Stop light switch
  • Stop light switch circuit
  • Stop light control relay
  • Stop light control relay circuit
  • Brake booster with master cylinder (Skid control ECU)
↑ 762 When the voltage at the IG1 terminal is 9.5 V or more and the stop light control relay drive output (STP0) is OFF, the signal at the STP terminal is different from the input signal at the STP2 for 5 seconds or more.
  • Stop light switch
  • Stop light switch circuit
  • Stop light control relay
  • Stop light control relay circuit
  • Brake booster with master cylinder (Skid control ECU)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.