Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSTOYOTA2012PRIUS THREEREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALLUBRICATION SYSTEMLUBRICATION SYSTEM (EXCEPT PLUG-IN)) (SERVICE INFORMATION)OIL PRESSURE SWITCHREMOVALREMOVAL

2012 Toyota Prius Three

Oil Pressure Switch: Removal: Removal

2012 Toyota Prius ThreeSECTION Removal

REMOVE FRONT WHEEL RH
REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY
1. Disconnect the oil pressure switch connector.
2. Using a 24 mm deep socket wrench, remove the oil pressure switch.
  
  Fig 1: Removing Oil Pressure Switch
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.