Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Connector Joining Wire Harness and Wire Harness
2012 Toyota Prius FiveSECTION Connector Joining Wire Harness and Wire Harness
| Code | See | Joining Wire Harness and Wire Harness (Connector Location) |
|---|---|---|
| AL2 | : LOCATION OF GROUND POINTS | Engine Room Main Wire and Instrument Panel Wire (Instrument Panel Reinforcement) |
| AL3 | ||
| AS1 | : LOCATION OF GROUND POINTS | Engine Room Main Wire and Floor No. 2 Wire (Cowl Side Panel RH) |
| DA1 | : LOCATION OF CONNECTOR JOINING WIRE HARNESS AND WIRE HARNESS | Engine Wire and Engine Room Main Wire (Left Engine Compartment) |
| LR1 | : LOCATION OF GROUND POINTS | Instrument Panel Wire and Floor Wire (Cowl Side Panel LH) |
| LS1 | : LOCATION OF GROUND POINTS | Instrument Panel Wire and Floor No. 2 Wire (Cowl Side Panel RH) |
| Lb1 | : LOCATION OF GROUND POINTS | Instrument Panel Wire and Switch Wire (Near Shift Lever) |
| NL1 | : LOCATION OF GROUND POINTS | Front Door RH Wire and Instrument Panel Wire (Cowl Side Panel RH) |
| NL2 | ||
| OL1 | : LOCATION OF GROUND POINTS | Front Door LH Wire and Instrument Panel Wire (Cowl Side Panel LH) |
| OL2 | ||
| PS1 | : LOCATION OF GROUND POINTS | Rear Door No. 1 Wire and Floor No. 2 Wire (Center Body Pillar RH) |
| QR1 | : LOCATION OF GROUND POINTS | Rear Door No. 2 Wire and Floor Wire (Center Body Pillar LH) |
| Sc1 | : LOCATION OF GROUND POINTS | Floor No. 2 Wire and HV Battery Pack No. 2 Wire (Right Luggage Compartment) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.