Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2011MATRIX AWD L4-2.4L (2AZ-FE)REPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSWIPER SWITCHSERVICE AND REPAIRINSTALLATION
2011 Toyota Matrix AWD L4-2.4L (2AZ-FE)
Installation
2011 Toyota Matrix AWD L4-2.4L (2AZ-FE)SECTION Installation
WIPER / WASHER: WIPER SWITCH: INSTALLATION
1. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY
(a) Engage the claw to install the windshield wiper switch assembly as shown in the illustration.
(b) Connect the 2 connectors.
2. INSTALL UPPER STEERING COLUMN COVER Installation
3. INSTALL LOWER STEERING COLUMN COVER Installation
4. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY Installation
5. INSTALL NO. 1 SWITCH HOLE BASE Installation
6. INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL (for Manual Transaxle) Installation
7. INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL (for Automatic Transaxle) Installation
8. INSTALL FRONT NO. 1 CONSOLE BOX INSERT Installation
9. INSTALL FRONT NO. 2 CONSOLE BOX INSERT Installation
10. INSTALL FRONT CONSOLE BOX ASSEMBLY
Installation
11. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for Manual Transaxle) Installation
12. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for Automatic Transaxle) Installation
13. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle) Installation
14. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transaxle) Installation
15. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY Installation
16. INSTALL METER HOOD SUB-ASSEMBLY Installation
17. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY Installation
18. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY Installation
19. TURN FRONT WHEELS TO FACE STRAIGHT AHEAD
20. ADJUST SPIRAL CABLE Installation
21. INSTALL STEERING WHEEL ASSEMBLY
Installation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.