Installation

2011 Toyota Matrix AWD L4-2.4L (2AZ-FE)SECTION Installation




MIRROR (INT): INNER REAR VIEW MIRROR: INSTALLATION

1. INSTALL INNER REAR VIEW MIRROR ASSEMBLY (w/o EC Mirror)

(a) Slide the inner rear view mirror assembly in the direction indicated by the arrow shown in the illustration to install it.





(b) Using a "TORX" socket wrench (T20), install the inner rear view mirror with the screw.

Torque : 1.5 Nm (15 kgf-cm, 13 in-lbf)

2. INSTALL INNER REAR VIEW MIRROR ASSEMBLY (w/ EC Mirror)

(a) Using a "TORX" socket wrench (T20), install the inner rear view mirror with the screw.





Torque : 1.5 Nm (15 kgf-cm, 13 in-lbf)

(b) Connect the connector.

3. INSTALL INNER REAR VIEW MIRROR COVER (w/ EC Mirror)

(a) Engage the 6 claws and temporarily install the inner rear view mirror cover.





(b) Slide the inner rear view mirror cover and engage the 2 claws in the direction indicated by narrow shown in the illustration to install the cover.




RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.