Installation

2011 Toyota Landcruiser V8-5.7L (3UR-FE)SECTION Installation




WIPER / WASHER: WIPER ECU: INSTALLATION

1. INSTALL WINDSHIELD WIPER ECU

(a) Install the windshield wiper ECU with the screw.





(b) Connect the 2 connectors.

2. INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL Installation

3. INSTALL INSTRUMENT PANEL BOX DOOR KNOB Installation

4. INSTALL NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH Installation

5. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY Installation

6. INSTALL COWL SIDE TRIM BOARD RH Installation

7. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

8. INSTALL FRONT DOOR SCUFF PLATE RH Installation

9. INSTALL INSTRUMENT SIDE PANEL RH Installation
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.