Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2011LANDCRUISER V8-5.7L (3UR-FE)REPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSRAIN SENSORSERVICE AND REPAIRREMOVAL
2011 Toyota Landcruiser V8-5.7L (3UR-FE)
Removal
2011 Toyota Landcruiser V8-5.7L (3UR-FE)SECTION Removal
WIPER / WASHER: RAIN SENSOR: REMOVAL
1. REMOVE RAIN SENSOR COVER
(a) Slide the No. 2 cover in the direction of the arrow labeled (1).
(b) Pull the stopper in the direction of the arrow labeled (2) to remove the rain sensor cover.
2. REMOVE RAIN SENSOR
(a) Release the stopper by pulling it in the direction of the arrow, and separate the rain sensor.
(b) Disconnect the connector and remove the rain sensor:
(c) When replacing the rain sensor tape.
(1) Remove the rain sensor tape.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.