Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2011LANDCRUISER V8-5.7L (3UR-FE)REPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSALIGNMENTSERVICE DATA
2011 Toyota Landcruiser V8-5.7L (3UR-FE)
Service Data
2011 Toyota Landcruiser V8-5.7L (3UR-FE)SECTION Service Data
SPECIFICATIONS: ALIGNMENT / HANDLING DIAGNOSIS: SERVICE DATA
Standard Vehicle Height (Unloaded Vehicle)
Standard Camber Inclination (Unloaded Vehicle)
Standard Caster Inclination (Unloaded Vehicle)
Standard Steering Axis Inclination (Unloaded Vehicle)
Standard Toe-in (Unloaded Vehicle)
Standard Wheel Turning Angle (Unloaded Vehicle)
MEASURE VEHICLE HEIGHT
Measuring points:
A : Ground clearance of the front drive shaft center
B : Ground clearance of the front adjusting cam bolt center
C : Ground clearance of the rear axle shaft center
D : Ground clearance of the rear lower control arm front side center
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.