Removal

2011 Toyota Landcruiser V8-5.7L (3UR-FE)SECTION Removal




3UR-FE ENGINE CONTROL: ECM: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. DISCONNECT CONNECTOR HOLDER BLOCK

(a) Remove the 3 bolts and move the connector holder block so that the ECM can be removed in the next step.





3. REMOVE ECM

(a) Raise the 2 levers while pushing the locks on the 2 levers.

NOTICE:
Make sure that the lock levers are raised 90° as shown in the illustration before disconnecting the connectors. Failure to do this may cause the connectors to break.





(b) Disconnect the 2 connectors.

(c) Remove the 4 bolts and ECM.





4. REMOVE GASKET

(a) Peel off the gasket.





(b) Spray gasket remover or equivalent on the remaining tape of the gasket.





NOTICE:
When using gasket remover or equivalent, cover the ECM connectors with a cloth.

(c) Remove the tape of the gasket without using bladed objects.




RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.