Installation

2011 Toyota Landcruiser V8-5.7L (3UR-FE)SECTION Installation




3UR-FE ENGINE CONTROL: IGNITION COIL AND SPARK PLUG: INSTALLATION

1. INSTALL SPARK PLUG

(a) Install the 8 spark plugs.

Torque : 21 Nm (214 kgf-cm, 15 ft-lbf)

2. INSTALL IGNITION COIL ASSEMBLY

(a) Install the 8 ignition coils with the 8 bolts.

Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

(b) Connect the 8 ignition coil connectors.





3. CONNECT WATER BY-PASS PIPE ASSEMBLY

(a) Connect the water by-pass pipe to the cylinder head cover and automatic transmission with the 3 bolts.





Torque : 18 Nm (184 kgf-cm, 13 ft-lbf)

(b) Connect the water by-pass pipe to the cylinder head cover and timing chain cover with the 2 bolts.





Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

4. INSTALL AIR CLEANER ASSEMBLY Installation

5. INSTALL AIR CLEANER HOSE ASSEMBLY Installation

6. INSTALL V-BANK COVER SUB-ASSEMBLY Installation

7. INSTALL NO. 2 ENGINE UNDER COVER Installation
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.