Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2011LANDCRUISER V8-5.7L (3UR-FE)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSENGINE TEMPERATURE SENSORSERVICE AND REPAIRINSTALLATION
2011 Toyota Landcruiser V8-5.7L (3UR-FE)
Installation
2011 Toyota Landcruiser V8-5.7L (3UR-FE)SECTION Installation
3UR-FE ENGINE CONTROL: ENGINE COOLANT TEMPERATURE SENSOR: INSTALLATION
1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR
(a) Install a new gasket to the sensor.
(b) Using a 19 mm deep socked wrench, install the sensor.
Torque : 20 Nm (200 kgf-cm, 14 ft-lbf)
(c) Connect the sensor connector.
2. ADD ENGINE COOLANT Service and Repair
3. INSPECT FOR COOLANT LEAK Testing and Inspection
4. INSTALL V-BANK COVER SUB-ASSEMBLY Installation
5. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY Installation
6. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH Installation
7. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH Installation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.