Installation

2011 Toyota Landcruiser V8-5.7L (3UR-FE)SECTION Installation




POWER OUTLETS (INT): REAR POWER OUTLET SOCKET: INSTALLATION

1. INSTALL REAR POWER OUTLET SOCKET

(a) Attach the 2 claws to install the socket.





2. INSTALL REAR POWER OUTLET SOCKET BEZEL

(a) Attach the 4 claws to install the bezel.





3. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH Installation

4. INSTALL REAR SEAT COVER CAP Installation

5. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK Installation

6. INSTALL REAR FLOOR MAT REAR SUPPORT PLATE Installation

7. INSTALL REAR DOOR SCUFF PLATE LH Installation

8. INSTALL REAR STEP COVER Installation

9. INSTALL REAR NO. 2 SEAT ASSEMBLY LH

(a) Install the rear No. 2 seat assembly LH Installation.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.