Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2011LANDCRUISER V8-5.7L (3UR-FE)REPAIR AND DIAGNOSISLIGHTING AND HORNSBRAKE LIGHT SWITCHSERVICE AND REPAIRINSTALLATION
2011 Toyota Landcruiser V8-5.7L (3UR-FE)
Installation
2011 Toyota Landcruiser V8-5.7L (3UR-FE)SECTION Installation
LIGHTING (EXT): STOP LIGHT SWITCH: INSTALLATION
1. INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER
(a) Install a new stop light switch mounting adjuster to the pedal support.
2. INSTALL STOP LIGHT SWITCH
(a) Install the stop light switch to the adjuster until it slightly touches the brake pedal.
NOTICE:
Do not depress the brake pedal.
(b) Turn the stop light switch quarter in clockwise to install it.
NOTICE:
Do not depress the brake pedal.
Torque : 1.5 Nm (15 kgf-cm, 13 in-lbf)
(c) Check the stop light switch clearance.
Stop light switch clearance:
1.5 to 2.5 mm (0.0590 to 0.0984 in.)
(d) Connect the wire harness clamp to the pedal support.
(e) Connect the connector to the stop light switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.