Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2011LANDCRUISER V8-5.7L (3UR-FE)REPAIR AND DIAGNOSISLIGHTING AND HORNSAMBIENT LIGHT SENSORTESTING AND INSPECTION
2011 Toyota Landcruiser V8-5.7L (3UR-FE)
Ambient Light Sensor: Testing and Inspection
2011 Toyota Landcruiser V8-5.7L (3UR-FE)SECTION Testing and Inspection
LIGHTING (EXT): AUTOMATIC LIGHT CONTROL SENSOR: ON-VEHICLE INSPECTION
1. INSPECT AUTOMATIC LIGHT CONTROL SENSOR
(a) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
(c) Reconnect the M2 sensor connector.
(d) Check the waveform of the M2 sensor connector.
Waveform:
HINT
If the ambient light becomes brighter, width A becomes narrower.
If the result is not as specified, there may be a malfunction in the sensor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.