Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2011LANDCRUISER V8-5.7L (3UR-FE)REPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGTESTING AND INSPECTIONCOMPONENT TESTS AND GENERAL DIAGNOSTICSIG POWER SOURCE CIRCUIT
2011 Toyota Landcruiser V8-5.7L (3UR-FE)
IG Power Source Circuit
2011 Toyota Landcruiser V8-5.7L (3UR-FE)SECTION IG Power Source Circuit
HEATING / AIR CONDITIONING: AIR CONDITIONING SYSTEM: IG Power Source Circuit
- IG Power Source Circuit
DESCRIPTION
The main power source is supplied to the air conditioning amplifier assembly when the engine switch is on (IG). The power source is used for operating the air conditioning amplifier assembly and servo motor, etc.
WIRING DIAGRAM
INSPECTION PROCEDURE
HINT
Start the engine before inspection. Check the relay or battery if the smart key system does not start.
PROCEDURE
1. INSPECT FUSE (ECU-IG NO. 2)
(a) Remove the ECU-IG NO. 2 fuse from the cowl side junction block LH.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- REPLACE FUSE
OK -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BATTERY AND BODY GROUND)
(a) Disconnect the E35 amplifier connector.
(b) Disconnect the E36 amplifier connector.
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
(d) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY Removal
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.