Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2011LANDCRUISER V8-5.7L (3UR-FE)REPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGREFRIGERANT PRESSURE SENSOR / SWITCHSERVICE AND REPAIRINSTALLATION
2011 Toyota Landcruiser V8-5.7L (3UR-FE)
Installation
2011 Toyota Landcruiser V8-5.7L (3UR-FE)SECTION Installation
HEATING / AIR CONDITIONING: AIR CONDITIONING PRESSURE SENSOR: INSTALLATION
1. INSTALL AIR CONDITIONER PRESSURE SENSOR
(a) Sufficiently apply compressor oil to a new O-ring and the fitting surface of the pressure sensor.
Compressor oil:
ND-OIL 8 or equivalent
(b) Install the O-ring on the pressure sensor.
(c) Install the pressure sensor.
Torque : 10.8 Nm (110 kgf-cm, 8 ft-lbf)
(d) Connect the connector.
2. CHARGE REFRIGERANT Service and Repair
3. WARM UP ENGINE Service and Repair
4. CHECK FOR REFRIGERANT GAS LEAK Service and Repair
5. INSTALL FRONT BUMPER COVER
(a) Install the front bumper cover Installation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.