Removal

2011 Toyota Landcruiser V8-5.7L (3UR-FE)SECTION Removal




DOOR LOCK: DOOR CONTROL RECEIVER: REMOVAL

1. REMOVE REAR NO. 2 SEAT ASSEMBLY RH

(a) Remove the rear No. 2 seat assembly RH Removal.

2. REMOVE REAR STEP COVER Removal

3. REMOVE REAR DOOR SCUFF PLATE RH Removal

4. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE Removal

5. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK Removal

6. REMOVE REAR SEAT COVER CAP Removal

7. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH Removal

8. REMOVE REAR UPPER PILLAR GARNISH RH Removal

9. REMOVE DOOR CONTROL RECEIVER

(a) Disconnect the connector.





(b) Remove the bolt and receiver.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.