Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2011LANDCRUISER V8-5.7L (3UR-FE)REPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYKEYLESS ENTRY RECEIVERSERVICE AND REPAIRINSTALLATION
2011 Toyota Landcruiser V8-5.7L (3UR-FE)
Installation
2011 Toyota Landcruiser V8-5.7L (3UR-FE)SECTION Installation
DOOR LOCK: DOOR CONTROL RECEIVER: INSTALLATION
HINT
A bolt without a torque specification is shown in the standard bolt chart Standard Bolt - Specified Torque For Standard Bolts.
1. INSTALL DOOR CONTROL RECEIVER
(a) Install the receiver with the bolt.
Torque : 15 Nm (153 kgf-cm, 11 ft-lbf)
(b) Connect the connector.
2. INSTALL REAR UPPER PILLAR GARNISH RH Installation
3. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY RH Installation
4. INSTALL REAR SEAT COVER CAP Installation
5. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK Installation
6. INSTALL REAR FLOOR MAT REAR SUPPORT PLATE Installation
7. INSTALL REAR DOOR SCUFF PLATE RH Installation
8. INSTALL REAR STEP COVER Installation
9. INSTALL REAR NO. 2 SEAT ASSEMBLY RH
(a) Install the rear No. 2 seat assembly RH Installation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.