Removal

2011 Toyota Landcruiser V8-5.7L (3UR-FE)SECTION Removal




CELLULAR COMMUNICATION: DCM(TELEMATICS TRANSCEIVER): REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
* w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
* When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE REAR CONSOLE END PANEL SUB-ASSEMBLY Removal

3. REMOVE DCM(TELEMATICS TRANSCEIVER)

(a) Disconnect the 3 connectors.





(b) Remove the 3 screws and telematics transceiver with bracket.

4. REMOVE NO. 2 TELEPHONE BRACKET





(a) Remove the 2 screws and telephone bracket LH.

(b) Remove the 2 screws and telephone bracket RH.




RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.