Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2011LANDCRUISER V8-5.7L (3UR-FE)REPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTEMERGENCY CONTACT MODULESERVICE AND REPAIRINSTALLATION
2011 Toyota Landcruiser V8-5.7L (3UR-FE)
Installation
2011 Toyota Landcruiser V8-5.7L (3UR-FE)SECTION Installation
CELLULAR COMMUNICATION: DCM(TELEMATICS TRANSCEIVER): INSTALLATION
1. INSTALL NO. 2 TELEPHONE BRACKET
(a) Install the telephone bracket RH to the telematics transceiver with the 2 screws.
Torque : 3.0 Nm (31 kgf-cm, 27 in-lbf)
(b) Install the telephone bracket LH to the telematics transceiver with the 2 screws.
Torque : 3.0 Nm (31 kgf-cm, 27 in-lbf)
2. INSTALL DCM(TELEMATICS TRANSCEIVER)
(a) Install the telematics transceiver with bracket with the 3 screws.
Torque : 3.0 Nm (31 kgf-cm, 27 in-lbf)
(b) Connect the 3 connectors.
3. INSTALL REAR CONSOLE END PANEL SUB-ASSEMBLY Installation
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
5. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light Diagnosis System.
6. PERFORM DCM ACTIVATION
(a) Perform DCM activation DCM Activation.
NOTICE:
When replacing the telematics transceiver, perform DCM activation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.