Rear Door LH Entry Lock Function Does Not Operate

THEFT DETERRENT / KEYLESS ENTRY: SMART KEY SYSTEM (for Entry Function): Rear Door LH Entry Lock Function does not Operate
- Rear Door LH Entry Lock Function does not Operate

DESCRIPTION

If the driver side rear door entry lock function does not operate but the entry unlock function operates, the communication line between the vehicle and electrical key transmitter is normal. The part at fault may be an entry lock switch circuit (certification ECU [smart key ECU assembly] -> driver side rear door outside handle [entry lock switch] -> driver side rear door electrical key oscillator).

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK POWER DOOR LOCK OPERATION

(a) When the master switch assembly door control switch is operated, check that the locked doors unlock.

OK:

Door locks operate normally.

NG -- GO TO POWER DOOR LOCK CONTROL SYSTEM Operation Check
OK -- Continue to next step.

2. READ VALUE USING TECHSTREAM (LOCK SWITCH)

(a) Using the Techstream, read the Data List.

Smart Key





OK:

On Techstream screen, item changes between ON and OFF according to above chart.

NG -- CHECK HARNESS AND CONNECTOR (REAR DOOR OUTSIDE HANDLE - DOOR ELECTRICAL KEY OSCILLATOR)

OK -- REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) Removal

3. CHECK HARNESS AND CONNECTOR (REAR DOOR OUTSIDE HANDLE - DOOR ELECTRICAL KEY OSCILLATOR)

(a) Disconnect the z28 oscillator connector.





(b) Disconnect the z27 handle connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

4. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU [SMART KEY ECU ASSEMBLY] - REAR DOOR OUTSIDE HANDLE)

(a) Disconnect the E30 ECU connector.





(b) Disconnect the z27 handle connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

5. INSPECT REAR DOOR OUTSIDE HANDLE LH

(a) Measure the resistance according to the value(s) in the table below.





Standard Resistance:





NG -- REPLACE REAR DOOR OUTSIDE HANDLE Removal
OK -- Continue to next step.

6. REPLACE DOOR ELECTRICAL KEY OSCILLATOR

(a) Replace the door electrical key oscillator Disassembly.

NEXT -- Continue to next step.

7. CHECK DOOR ELECTRICAL KEY OSCILLATOR (OPERATION)

(a) Check that the entry function operates normally.

OK:

Operates normally.

NG -- REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) Removal

OK -- END (DOOR ELECTRICAL OSCILLATOR IS DEFECTIVE)