Navigation System

2011 Toyota Landcruiser V8-5.7L (3UR-FE)SECTION Navigation System




NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: B15C0, B15C1: Short in GPS Antenna
B15C1 - Open in GPS Antenna

DESCRIPTION

These DTCs are stored when a malfunction occurs in the navigation antenna assembly.





INSPECTION PROCEDURE

PROCEDURE

1. CHECK CONNECTION OF ANTENNA CABLE

(a) Check if the navigation antenna cable is securely connected to the display and navigation module display.

OK:

Navigation antenna cable is securely connected.

NG -- SECURELY CONNECT NAVIGATION ANTENNA CABLE
OK -- Continue to next step.

2. REPLACE NAVIGATION ANTENNA ASSEMBLY

(a) Replace the navigation antenna assembly with a known good one and recheck for DTCs Removal.

(1) Clear the DTCs Reading and Clearing Diagnostic Trouble Codes.

(2) Recheck for DTCs.

OK:

No DTCs are output.

NG -- REPLACE DISPLAY AND NAVIGATION MODULE DISPLAY Removal

OK -- END
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.