Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2011FJ CRUISER 2WD V6-4.0L (1GR-FE)REPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSWASHER FLUID LEVEL SWITCHTESTING AND INSPECTION
2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)
Washer Fluid Level Switch: Testing and Inspection
2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)SECTION Testing and Inspection
WIPER AND WASHER: WASHER LEVEL WARNING SWITCH: INSPECTION
1. INSPECT LEVEL WARNING SWITCH ASSEMBLY
HINT
The following check should be performed with the windshield washer motor and pump installed to the washer jar.
(a) Fill the washer jar with washer fluid.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
If the result is not as specified, replace the level warning switch assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.