Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2011FJ CRUISER 2WD V6-4.0L (1GR-FE)REPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSWINDOW REGULATORTESTING AND INSPECTIONON-VEHICLE INSPECTION
2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)
On-Vehicle Inspection
2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)SECTION On-Vehicle Inspection
WINDSHIELD / WINDOW GLASS: POWER WINDOW REGULATOR MOTOR: ON-VEHICLE INSPECTION
1. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
(a) Inspect the operation of the PTC inside the power window regulator motor.
NOTICE:
The work must be performed with the power window regulator and door glass installed on the vehicle.
(1) Connect an electrical tester DC 400 A probe to the wire harness of terminal 1.
NOTICE:
Match the arrow mark of the probe with the direction of the current flow.
(2) Fully close the door glass by pressing the power window UP switch. Wait for approximately 60 seconds.
(3) Continue to press the power window UP switch and measure how long it takes for the electrical current to change from a range of 16 to 28 A to approximately 1 A (Inspection of current shut-off).
Standard:
4 to 90 seconds
(4) Check that the door glass moves downward when the power window DOWN switch is pressed.
If the result is not as specified, replace the power window regulator motor.
2. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH
(a) Inspect the operation of the PTC inside the power window regulator motor.
NOTICE:
The work must be performed with the power window regulator and door glass installed on the vehicle.
(1) Connect an electrical tester DC 400 A probe to the wire harness of terminal 2.
NOTICE:
Match the arrow mark of the probe with the direction of the current flow.
(2) Fully close the door glass by pressing the power window UP switch. Wait for approximately 60 seconds.
(3) Continue to press the power window UP switch and measure how long it takes for the electrical current to change from a range of 16 to 28 A to approximately 1 A (Inspection of current shut-off).
Standard:
4 to 90 seconds
(4) Check that the door glass moves downward when the power window DOWN switch is pressed.
If the result is not as specified, replace the power window regulator motor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.