Symptom Related Diagnostic Procedures

2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)SECTION Symptom Related Diagnostic Procedures




A750E AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMISSION SYSTEM: PROBLEM SYMPTOMS TABLE

HINT
* If no DTCs are displayed during the diagnostic trouble code check although the trouble still occurs, check the electrical circuits for each symptom in the order given in the charts on the following pages and proceed to the page given for troubleshooting.

* The Matrix Chart is divided into 2 chapters.

* *1: Denotes that when there are malfunctions in the circuit, DTCs may be set.

Chapter 1: Electronic Circuit Matrix Chart

Refer to the table below when the cause of the trouble is considered to be electrical.

If the trouble still occurs even though there are no abnormalities in any of the other circuits, check and replace the ECM.






















Chapter 2: On-Vehicle Repair and Off-Vehicle Repair




















RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.