Component Tests and General Diagnostics

DIFFERENTIAL: DIFFERENTIAL SYSTEM: INSPECTION

1. INSPECT DIFFERENTIAL LOCK SYSTEM





(a) Inspect the indicator light.

(1) Check that the indicator light lights up for approximately 1 second when the ignition switch is turned ON.

(b) Inspect the differential lock operation.

(1) Jack up the vehicle then start the engine.

(2) Shift the transfer shift lever to L position.

(3) When the differential lock control switch is set to the ON position, the indicator light is pushed on. Differential lock is applied to the rear wheel at this time.

HINT
If the gears of the differential lock system are not engaged, the indicator light remains blinking, so rotate the tires to engage the gear.

(4) When the differential lock control switch is in the OFF position, the indicator light goes off. The rear differential lock is released at this time.

(5) Check the voltage between the terminals of the four wheel drive control ECU when switching the differential control ON, with the speedometer registering approximately 5 mph (8 km/h) or more.





Standard voltage:





(6) Return the differential lock control switch to OFF.

(7) Stop the engine and lower the vehicle.

2. CHECK WIRE HARNESS AND CONNECTOR





(a) Inspect the system circuit with the connector disconnected.

(1) Disconnect the connector from the four wheel drive control ECU and inspect the connector on the wire harness side, as shown in the table.

Standard:





HINT
If the circuit is not as specified, check and repair or replace the trouble part shown in the table above.

3. CHECK 4 WHEEL DRIVE CONTROL ECU NO.2





(a) Inspect the system circuit with the connector connected.

(1) Turn the ignition switch to the ON position.

(2) Shift the transfer shift lever to the L position.

(3) Using a voltmeter, measure the voltage when the differential lock control switch is in the position, as shown in the table.

Standard voltage:





HINT
*The rear differential should be locked mechanically.

* If the circuit is not as specified, replace the ECU.

(4) Install the ECU in place.

4. INSPECT DIFFERENTIAL LOCK COMPONENTS

(a) Inspect the relay operation.





(1) Jack up the vehicle.

(2) Use a heater main relay and connect it, as shown below.

NOTICE:
Connect the terminals being careful not to touch the neighboring terminals or metallic parts of the relay housing.

(3) Rotate the tire and check that the differential locks.





* If the operation is not as specified, replace the actuator.

5. INSPECT REAR DIFFERENTIAL LOCK SWITCH





(a) Inspect the differential lock switch.

(1) Inspect the resistance between terminals 1and 4.

Standard resistance:

Below 1 Ohms

HINT
If the result is not as specified, replace the switch.

6. INSPECT REAR DIFFERENTIAL LOCK INDICATOR SWITCH





(a) Inspect the No. 4 transfer indicator switch.

(1) Measure the resistance between the terminals when the switch is pushed (differential connected position).

Standard resistance:

Below 1 Ohms

(2) Measure the resistance between the terminals when switch is released (differential disconnected position).

Standard resistance:

10 kOhms or higher

HINT
If the operation is not as specified, replace the switch.

(b) Inspect the L position switch Freeze Frame Data.

(c) Inspect the vehicle speed sensor .