Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2011FJ CRUISER 2WD V6-4.0L (1GR-FE)REPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSBRAKES AND TRACTION CONTROLBRAKE ROTOR/DISC
2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)
Brake Rotor/Disc
2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)SECTION Brake Rotor/Disc
DISC THICKNESS
FRONT BRAKE
Standard thickness 28.0 mm (1.102 in.)
Minimum thickness 26.0 mm (1.024 in.)
REAR BRAKE
Standard thickness 18.0 mm (0.709 in.)
Minimum thickness 16.0 mm (0.630 in.)
DISC RUNOUT
FRONT BRAKE
Using a dial indicator, measure the disc runout 10 mm (0.39 in.) away from the outer edge of the front disc.
Maximum disc runout 0.05 mm (0.0020 in.)
REAR BRAKE
Using a dial indicator, measure the disc runout 10 mm (0.39 in.) away from the outer edge of the rear disc.
Maximum disc runout 0.20 mm (0.0079 in.)
FRONT BRAKE
Standard thickness 28.0 mm (1.102 in.)
Minimum thickness 26.0 mm (1.024 in.)
REAR BRAKE
Standard thickness 18.0 mm (0.709 in.)
Minimum thickness 16.0 mm (0.630 in.)
DISC RUNOUT
FRONT BRAKE
Using a dial indicator, measure the disc runout 10 mm (0.39 in.) away from the outer edge of the front disc.
Maximum disc runout 0.05 mm (0.0020 in.)
REAR BRAKE
Using a dial indicator, measure the disc runout 10 mm (0.39 in.) away from the outer edge of the rear disc.
Maximum disc runout 0.20 mm (0.0079 in.)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.