Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2011FJ CRUISER 2WD V6-4.0L (1GR-FE)REPAIR AND DIAGNOSISRESTRAINTS AND SAFETY SYSTEMSTESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURES
2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)
Scan Tool Testing and Procedures
2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)SECTION Scan Tool Testing and Procedures
SUPPLEMENTAL RESTRAINT SYSTEM: OCCUPANT CLASSIFICATION SYSTEM: DATA LIST / ACTIVE TEST
HINT
By accessing the Data List displayed by a Techstream, you can check values of switches and sensors without removing any parts. Reading the Data List as the first step of troubleshooting is one method to shorten diagnostic time.
1. DATA LIST FOR OCCUPANT CLASSIFICATION ECU
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to the on position.
(c) Following the display on the tester screen, read the Data List.
Occupant Detect:
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.