Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2011FJ CRUISER 2WD V6-4.0L (1GR-FE)REPAIR AND DIAGNOSISRESTRAINTS AND SAFETY SYSTEMSSEAT BELT SYSTEMSTESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURES
2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)
Scan Tool Testing and Procedures
2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)SECTION Scan Tool Testing and Procedures
SEAT BELT: SEAT BELT WARNING SYSTEM: DATA LIST / ACTIVE TEST
1. READ DATA LIST
HINT
By accessing the Data List using a Techstream, values of the switches and sensors can be read without removing any parts. Reading the DATA LIST is the first step of troubleshooting and is one method of shortening labor time.
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch ON and turn the tester ON.
(c) Enter the Data List by following the prompts displayed on the tester screen.
SRS Airbag
Occupant Detect
Body
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.