Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2011FJ CRUISER 2WD V6-4.0L (1GR-FE)REPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - RESTRAINTS AND SAFETY SYSTEMSAIR BAG CONTROL MODULESERVICE AND REPAIRREMOVAL
2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)
Removal
2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)SECTION Removal
SUPPLEMENTAL RESTRAINT SYSTEM: CENTER AIRBAG SENSOR ASSEMBLY: REMOVAL
1. PRECAUTION
CAUTION:
Read "PRECAUTION" thoroughly before servicing Service Precautions.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.
3. REMOVE INSTRUMENT PANEL GARNISH LH Removal
4. REMOVE INSTRUMENT PANEL GARNISH RH Removal
5. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY Removal
6. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle) Removal
7. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for 4WD) Removal
8. REMOVE PARKING BRAKE HOLE COVER SUB-ASSEMBLY Removal
9. REMOVE CONSOLE UPPER REAR PANEL SUB-ASSEMBLY Removal
10. REMOVE BOX BOTTOM MAT Removal
11. REMOVE FRONT CONSOLE BOX Removal
12. REMOVE CONSOLE UPPER PANEL NO.1 GARNISH Removal
13. REMOVE INSTRUMENT LOWER COVER SUB-ASSEMBLY Removal
14. REMOVE CENTER AIRBAG SENSOR ASSEMBLY
(a) Disconnect the holder (with connectors) from the center airbag sensor assembly.
(b) Remove 3 bolts and the center airbag sensor assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.