SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2011FJ CRUISER 2WD V6-4.0L (1GR-FE)REPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - POWERTRAIN MANAGEMENTRELAYS AND MODULES - COMPUTERS AND CONTROL SYSTEMSENGINE CONTROL MODULESERVICE AND REPAIRINSTALLATION
2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)

Installation

2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)SECTION Installation




1GR-FE ENGINE CONTROL SYSTEM: ECM: INSTALLATION

1. INSTALL NO. 2 ECM BRACKET

(a) Install the No. 2 ECM bracket with the 2 screws.

Torque : 3.0 Nm (31 kgf-cm, 27 in-lbf)

2. INSTALL ECM BRACKET

(a) Install the ECM bracket with the 2 screws.

Torque : 3.0 Nm (31 kgf-cm, 27 in-lbf)

3. INSTALL ECM

(a) Install the ECM with the 3 nuts.

Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)

(b) Connect the 6 connectors.

4. INSTALL 4 WHEEL DRIVE CONTROL ECU NO.2 (for Automatic Transmission 4WD)

(a) Install the four wheel drive control ECU with the bolt.

Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

(b) Connect the connector.

5. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY Installation

6. PERFORM INITIALIZATION Installation
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.