Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSTOYOTA2011FJ CRUISER 2WD V6-4.0L (1GR-FE)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTTECHNICAL SERVICE BULLETINSALL TECHNICAL SERVICE BULLETINSCANADA - ENGINE CONTROLS/FUEL SYSTEM - MIL ON/DTCS P2111/P2112
2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)
Canada - Engine Controls/Fuel System - MIL ON/DTCs P2111/P2112
2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)SECTION Canada - Engine Controls/Fuel System - MIL ON/DTCs P2111/P2112
Bulletin
T-TCI-3661
Issue Date
December 2, 2011
Market
Canada
Title
MIL "ON" DTC P2111/P2112
Service Category
Engine/Hybrid System
Section
Engine Control
Market
Canada
APPLICABILITY:
INTRODUCTION:
Some 2010 - 2011 model year 4Runner and FJ Cruiser vehicles equipped with the 1GR-FE (4.0 L) engine may exhibit an intermittent MIL "ON" condition with Diagnostic Trouble Codes (DTCs) P2111 and/or P2112 (Throttle Actuator Control System) stored in the Engine Control Module or ECM (SAE Term: Powertrain Control Module/PCM). Use the following repair procedure to address this condition.
PRODUCTION CHANGE INFORMATION:
This TSB applies to vehicles produced BEFORE the Production Change Effective VIN shown.
PARTS INFORMATION:
WARRANTY INFORMATION:
REQUIRED TOOLS & EQUIPMENT:
NOTE
Additional Techstream or Techstream LITE units may be ordered by completing the order form on ETAS (Tools > Tools and Equipment > Order Form) and faxing it to (416) 431-8342.
REPAIR PROCEDURE:
1. Using ETAS Techstream, retrieve any stored DTCs.
2. If DTC P2111 or P2112 are present, replace the throttle body assembly.
Refer to ETAS/TIS Library, applicable model and model year Repair Manual:
- 2010 4Runner:
Engine/Hybrid System - Engine Control - "1GR-FE Engine Control: Throttle Body: Removal / Installation"
- 2011 4Runner:
Engine/Hybrid System - Engine Control - "1GR-FE Engine Control: Throttle Body: Removal / Installation"
- 2010 FJ Cruiser:
Engine/Hybrid System - Engine Control - "1GR-FE Engine Control System: Throttle Body: Removal / Installation"
- 2011 FJ Cruiser:
Engine/Hybrid System - Engine Control - "1GR-FE Engine Control System: Throttle Body: Removal / Installation"
3. After the repair is complete, clear any DTCs, and confirm normal system operation and that there are NO pending DTCs.
NOTE:
Issue of this Technical Service Bulletin is to ensure that proper repair information is available. IT DOES NOT CONSTITUTE AN AUTHORIZATION FOR REPAIR. Normal provisions of the formal warranty policy, as applicable, will apply.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.