SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2011FJ CRUISER 2WD V6-4.0L (1GR-FE)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTRELAYS AND MODULES - POWERTRAIN MANAGEMENTRELAYS AND MODULES - COMPUTERS AND CONTROL SYSTEMSMAIN RELAY (COMPUTER/FUEL SYSTEM)TESTING AND INSPECTIONCIRCUIT OPENING RELAY
2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)

Circuit Opening Relay

2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)SECTION Circuit Opening Relay




1GR-FE ENGINE CONTROL SYSTEM: CIRCUIT OPENING RELAY: ON-VEHICLE INSPECTION

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE CIRCUIT OPENING RELAY





(a) Remove the relay block cover upper.

(b) Remove the circuit opening relay.

3. INSPECT CIRCUIT OPENING RELAY





(a) Check the resistance.

(1) Using an ohmmeter, measure the resistance between the terminals.

Standard resistance:





If the result is not as specified, replace the circuit opening relay.

4. INSTALL CIRCUIT OPENING RELAY

(a) Install the circuit opening relay.

(b) Install the relay block cover upper.

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 3.9 Nm (40 kgf-cm, 35 in-lbf)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.