Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2011FJ CRUISER 2WD V6-4.0L (1GR-FE)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSCRANKSHAFT POSITION SENSORSERVICE AND REPAIRINSTALLATION
2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)
Installation
2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)SECTION Installation
1GR-FE ENGINE CONTROL SYSTEM: CRANKSHAFT POSITION SENSOR: INSTALLATION
1. INSTALL CRANKSHAFT POSITION SENSOR
(a) Apply a light coat of engine oil to the O-ring of the sensor.
Text in Illustration
NOTICE:
* When reusing the sensor, inspect the O-ring.
* If the O-ring has scratches or cuts, replace the sensor.
(b) Install the sensor with the bolt.
Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)
(c) Connect the sensor connector.
2. INSTALL COOLER COMPRESSOR ASSEMBLY Installation
3. INSTALL GENERATOR ASSEMBLY
(a) Install the generator Installation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.