Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2011FJ CRUISER 2WD V6-4.0L (1GR-FE)REPAIR AND DIAGNOSISPOWER AND GROUND DISTRIBUTIONRELAYS AND MODULES - POWER AND GROUND DISTRIBUTIONPOWER DISTRIBUTION MODULESERVICE AND REPAIRREMOVAL
2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)
Removal
2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)SECTION Removal
OTHER SYSTEM: VOLTAGE INVERTER: REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE REAR SEAT BACK BOARD CARPET ASSEMBLY RH Removal
3. REMOVE REAR SEATBACK ASSEMBLY RH Removal
4. REMOVE REAR FLOOR BOARD Removal
5. REMOVE REAR FLOOR MAT SUPPORT PLATE Removal
6. REMOVE REAR FLOOR MAT ASSEMBLY Removal
7. REMOVE FRONT DOOR SCUFF PLATE RH Removal
8. REMOVE REAR DOOR SCUFF PLATE RH Removal
9. REMOVE PACKAGE HOLDER NET HOOK (w/o Amplifier Box Speaker Assembly) Removal
10. REMOVE QUARTER TRIM POCKET TRAY (w/o Amplifier Box Speaker Assembly) Removal
11. REMOVE SIDE TRIM COVER (w/o Amplifier Box Speaker Assembly) Removal
12. REMOVE QUARTER TRIM POCKET (w/o Amplifier Box Speaker Assembly) Removal
13. REMOVE DECK SIDE GARNISH (w/ Amplifier Box Speaker Assembly) Removal
14. REMOVE SPEAKER MOUNTING COVER (w/ Amplifier Box Speaker Assembly) Removal
15. REMOVE AMPLIFIER BOX SPEAKER ASSEMBLY (w/ Amplifier Box Speaker Assembly) Removal
16. REMOVE LAP BELT OUTER ANCHOR COVER Removal
17. REMOVE REAR SEAT OUTER BELT ASSEMBLY RH Removal
18. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH Removal
19. REMOVE VOLTAGE INVERTER ASSEMBLY
(a) Remove the bolt and the ground wire.
(b) Disconnect the 2 connectors and the wire harness clamp.
(c) Remove the 5 bolts and remove the voltage inverter assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.