Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2011FJ CRUISER 2WD V6-4.0L (1GR-FE)REPAIR AND DIAGNOSISPOWER AND GROUND DISTRIBUTIONRELAYS AND MODULES - POWER AND GROUND DISTRIBUTIONPOWER DISTRIBUTION MODULESERVICE AND REPAIRINSTALLATION
2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)
Installation
2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)SECTION Installation
OTHER SYSTEM: VOLTAGE INVERTER: INSTALLATION
1. INSTALL VOLTAGE INVERTER ASSEMBLY
(a) Install the voltage inverter assembly with the 5 bolts.
Torque : 8.5 Nm (87 kgf-cm, 75 in-lbf)
(b) Connect the 2 connectors and install the wire harness clamp.
(c) Install the ground wire with the bolt.
Torque : 6.9 Nm (70 kgf-cm, 61 in-lbf)
2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH Installation
3. INSTALL REAR SEAT OUTER BELT ASSEMBLY RH Installation
4. INSTALL LAP BELT OUTER ANCHOR COVER Installation
5. INSTALL QUARTER TRIM POCKET (w/o Amplifier Box Speaker Assembly) Installation
6. INSTALL SIDE TRIM COVER (w/o Amplifier Box Speaker Assembly) Installation
7. INSTALL QUARTER TRIM POCKET TRAY (w/o Amplifier Box Speaker Assembly) Installation
8. INSTALL PACKAGE HOLDER NET HOOK (w/o Amplifier Box Speaker Assembly) Installation
9. INSTALL AMPLIFIER BOX SPEAKER ASSEMBLY (w/ Amplifier Box Speaker Assembly) Installation
10. INSTALL SPEAKER MOUNTING COVER (w/ Amplifier Box Speaker Assembly) Installation
11. INSTALL DECK SIDE GARNISH (w/ Amplifier Box Speaker Assembly) Installation
12. INSTALL REAR DOOR SCUFF PLATE RH Installation
13. INSTALL FRONT DOOR SCUFF PLATE RH Installation
14. INSTALL REAR FLOOR MAT ASSEMBLY Installation
15. INSTALL REAR FLOOR MAT SUPPORT PLATE Installation
16. INSTALL REAR FLOOR BOARD Installation
17. INSTALL REAR SEATBACK ASSEMBLY RH Installation
18. INSTALL REAR SEAT BACK BOARD CARPET ASSEMBLY RH Installation
19. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque : 3.9 Nm (40 kgf-cm, 35 in-lbf)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.