SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2011FJ CRUISER 2WD V6-4.0L (1GR-FE)REPAIR AND DIAGNOSISPOWER AND GROUND DISTRIBUTIONAUXILIARY POWER OUTLET SWITCHSERVICE AND REPAIRINSTALLATION
2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)

Installation

2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)SECTION Installation




OTHER SYSTEM: INVERTER MAIN SWITCH: INSTALLATION

1. INSTALL INVERTER MAIN SWITCH BULB

(a) Turn the inverter main switch bulb, in the direction indicated by the arrow in the illustration, to install it.





2. INSTALL INVERTER MAIN SWITCH

(a) Engage the 2 clips and install the inverter main switch.





3. INSTALL INSTRUMENT LOWER COVER SUB-ASSEMBLY Installation

4. INSTALL CONSOLE BOX ASSEMBLY REAR Installation

5. INSTALL BOX BOTTOM MAT Installation

6. INSTALL CONSOLE UPPER REAR PANEL SUB-ASSEMBLY Installation

7. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for 4WD) Installation

8. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission) Installation

9. INSTALL PARKING BRAKE HOLE COVER SUB-ASSEMBLY Installation

10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 3.9 Nm (40 kgf-cm, 35 in-lbf)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.