Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2011FJ CRUISER 2WD V6-4.0L (1GR-FE)REPAIR AND DIAGNOSISMAINTENANCESERVICE INTERVALSMAINTENANCE INDICATOR RESET
2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)
Maintenance Indicator Reset
2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)SECTION Maintenance Indicator Reset
After changing the engine oil, the oil change system should be reset. Perform the following procedures:
Step 1: Turn the engine switch off with the odometer reading shown.
Step 2: Turn the engine switch to the ON position while holding down the trip meter reset button.
Step 3: Continue to press and hold the button until the odometer displays 000000.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.