Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2011FJ CRUISER 2WD V6-4.0L (1GR-FE)REPAIR AND DIAGNOSISLIGHTING AND HORNSTESTING AND INSPECTIONSYMPTOM RELATED DIAGNOSTIC PROCEDURES
2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)
Symptom Related Diagnostic Procedures
2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)SECTION Symptom Related Diagnostic Procedures
LIGHTING: LIGHTING SYSTEM: PROBLEM SYMPTOMS TABLE
HINT
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Headlight and Taillight System
* *1: w/o Daytime Running Light System
* *2: w/ Daytime Running Light System
Daytime Running Light System
Stop Light System
Turn Signal Light System
Hazard Warning Light System
Map Light System
Room Light System
Rear Room Light System
Light Auto Turn Off System
Illuminated Entry System
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.