Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2011FJ CRUISER 2WD V6-4.0L (1GR-FE)REPAIR AND DIAGNOSISLIGHTING AND HORNSBRAKE LAMPSERVICE AND REPAIROVERHAULDISASSEMBLY
2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)
Disassembly
2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)SECTION Disassembly
LIGHTING: REAR COMBINATION LIGHT ASSEMBLY: DISASSEMBLY
1. REMOVE REAR COMBINATION LIGHT GASKET
(a) Remove the rear combination light gasket.
NOTICE:
* Detach the gasket if it adheres to the body.
* Do not reuse a removed gasket. Replace it with a new one to prevent water from entering.
2. REMOVE TAIL AND STOP LIGHT BULB
(a) Turn the rear combination light socket and bulb, in the direction indicated by the arrow in the illustration, to remove them.
(b) Remove the rear combination light bulb from the light socket.
3. REMOVE BACK UP LIGHT BULB
(a) Turn the rear combination light socket and bulb, in the direction indicated by the arrow in the illustration, to remove them.
(b) Remove the rear combination light bulb from the light socket.
4. REMOVE REAR TURN SIGNAL LIGHT BULB
(a) Turn the rear combination light socket and bulb, in the direction indicated by the arrow in the illustration, to remove them.
(b) Remove the rear combination light bulb from the light socket.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.