Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2011FJ CRUISER 2WD V6-4.0L (1GR-FE)REPAIR AND DIAGNOSISENGINE, COOLING AND EXHAUSTENGINECYLINDER BLOCK ASSEMBLYCONNECTING RODSPECIFICATIONS
2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)
Connecting Rod: Specifications
2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)SECTION Specifications
PISTON SUB-ASSEMBLY WITH CONNECTING ROD
Install the connecting rod cap bolts.
The cap bolts are tightened in 2 progressive steps.
Step 1:
Install and alternately tighten the bolts of each connecting rod cap in several steps.
Torque 25 Nm (250 kgf-cm, 18 ft-lbf)
Mark the front side of each connecting rod cap bolt with paint.
Step 2:
Tighten the cap bolts 90°.
Check that the painted mark is now at a 90° angle to the front.
Check that the crankshaft turns smoothly.
Connecting Rod Side Clearance, Out-of-round, & Diameter
Install the connecting rod cap bolts.
The cap bolts are tightened in 2 progressive steps.
Step 1:
Install and alternately tighten the bolts of each connecting rod cap in several steps.
Torque 25 Nm (250 kgf-cm, 18 ft-lbf)
Mark the front side of each connecting rod cap bolt with paint.
Step 2:
Tighten the cap bolts 90°.
Check that the painted mark is now at a 90° angle to the front.
Check that the crankshaft turns smoothly.
Connecting Rod Side Clearance, Out-of-round, & Diameter
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.