SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2011FJ CRUISER 2WD V6-4.0L (1GR-FE)REPAIR AND DIAGNOSISCRUISE CONTROLCLUTCH SWITCHSERVICE AND REPAIRREMOVAL
2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)

Removal

2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)SECTION Removal




CRUISE CONTROL: CLUTCH SWITCH: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE FRONT DOOR SCUFF PLATE LH Removal

3. REMOVE FRONT FLOOR FOOTREST Removal

4. REMOVE FOOTREST CLIP Removal

5. REMOVE COWL SIDE TRIM BOARD LH Removal

6. REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY Removal

7. SEPARATE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY Removal

8. REMOVE INSTRUMENT PANEL FINISH PLATE Removal

9. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH Removal

10. REMOVE LOWER INSTRUMENT PANEL LH Removal

11. REMOVE INSTRUMENT PANEL SIDE BRACKET

(a) Remove the bolt and remove the instrument panel side bracket.





12. SEPARATE MAIN BODY ECU (DRIVER SIDE J/B)

(a) Remove the 2 nuts and separate the main body ECU.





13. REMOVE CLUTCH SWITCH ASSEMBLY

(a) Disconnect the connector.





(b) Loosen the nut and remove the clutch switch assembly.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.