Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2011FJ CRUISER 2WD V6-4.0L (1GR-FE)REPAIR AND DIAGNOSISBODY AND FRAMELOCKSTRUNK / LIFTGATE LOCKSERVICE AND REPAIRBACK WINDOW LOCKINSTALLATION
2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)
Installation
2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)SECTION Installation
WINDSHIELD / WINDOW GLASS: BACK WINDOW LOCK: INSTALLATION
1. INSTALL BACK WINDOW LOCK
(a) Install the back window lock with the 3 bolts.
Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf)
(b) Connect the connector and clamp.
2. INSTALL BACK DOOR SERVICE HOLE COVER Reassembly
3. INSTALL BACK DOOR TRIM BOARD Reassembly
4. INSTALL DOOR TRIM RETAINER CAP Reassembly
5. INSTALL BACK DOOR TRIM COVER RH Reassembly
6. INSTALL BACK DOOR TRIM COVER LH
HINT
Use the same procedure as for the RH side.
7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque : 3.9 Nm (40 kgf-cm, 35 in-lbf)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.